2000 Hyundai Tiburon STRUT ASSEMBLY Removal
download 1. Raise and support vehicle. Remove wheel assembly. Disconnect brakeline bracket from strut assembly. Support control arm. Remove strut-to-steering knuckle bolts. Separate strut from steering...
View Article1998 Ford Windstar Strut and Spring Assembly REMOVAL AND INSTALLATION
download Removal 1. Raise the vehicle on a hoist. 2. Remove the front wheel and tire assembly. 3. CAUTION: To avoid damage to the 6mm drive hole in the front stabilizer bar link ball stud, do not use...
View Article1996 Nissan Altima GLE TIMING CHAIN Removal
download 1. Release fuel pressure. See FUEL PRESSURE RELEASE . Drain coolant from radiator and cylinder block. Drain engine oil. Disconnect all necessary coolant hoses, electrical connectors, vacuum...
View Article2001 Toyota Sienna CE Trunk / Liftgate Service and Repair DISASSEMBLY
download 1. REMOVE BACK DOOR ASSIST GRIP a. Using a screwdriver, open the covers. HINT: Tape the screwdriver tip before use. b. Remove the 2 screws and assist grip. 2. REMOVE BACK DOOR PULL STRAP a....
View Article1994 Ford Mustang A/C Evaporator Housing Removal and Installation
download 1. Disconnect battery ground cable (14301) . 2. Remove two console armrest mounting access covers (047A62) at rear of console panel (045A36) (snaps out) to gain access to armrest retaining...
View Article1997 Cadillac Catera Drive Axles, Bearings and Joints: Rear Suspension...
download 1. Raise and support the vehicle. 2. Remove the tire and wheel assembly. 3. Use the J 42066 and use a 1/2 inch breaker bar to counter hold the rear wheel hub. Important: DO NOT allow the drive...
View Article1997 Ford Explorer Cable and Conduit Parking Brake Rear Removal
download 1. NOTE: Make sure the parking brake control is fully released. Relieve the tension on the parking brake system. 1. Pull the front parking brake cable and conduit. 2. Insert a suitable...
View Article2004 Ford F-150 Rear Axle Differential Cover Axle Shaft Oil Seal and Rear...
download 1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to...
View Article1993 Mitsubishi Montero TRANSFER CASE DISASSEMBLY
download Disassembly (Ram-50) 1) Remove both 4WD indicator switches and steel balls. Remove speedometer gear assembly. Remove output shaft cover, gasket, wave spring and spacer. See Fig. 3. Remove rear...
View Article1995 Ford Thunderbird Spring REMOVAL AND INSTALLATION
download Removal 1. Raise vehicle on hoist. Refer to Section 00-02. 2. Remove rear wheel and tire assembly. 3. Remove rear stabilizer bar link and bushing link nuts at both ends of rear stabilizer bar...
View Article